Leysop 3mm RTP Pockels Cell

                      This oscilloscope trace shows the measurement of the optical transmission in a single-pass setup
                      measured with a photodiode of risetime 1nsec.
                      Parameters: 1064nm, 1.2kV, time difference of On/Off triggers 50nsec.

LR5_PP_50ns.gif

 

                      This oscilloscope trace shows the measurement of the optical transmission in a single-pass setup
                      measured with a photodiode of risetime 1nsec. In order to reduce rise and fall times,the time
                      difference between the On/Off triggers was reduced, at the same time increasing the drive voltage
                      to the cell.
                      Parameters: 1064nm, 1.5kV, time difference of On/Off triggers 5nsec.


LR3_PP_5ns.gif

 

                      This oscilloscope trace shows the optical measurement of a 10Mhz burst of pulses using this
                      3mm RTP Pockels cell in a single-pass setup measured with a photodiode of risetime 1nsec.
                      Note the time difference between the pulses of about 100nsec and the instantaneous start
                      of the pulse sequence. The expanded trace below shows an expansion
                      of the start phase.
                      Parameters: 1064nm, 1.5kV, 10MHz, Burst length 10msec


LR3_Burst_10MHz.gif

 

 

hrs026.GIF (1088 bytes)

||  home  ||  products  ||  contact  ||

hr026.gif (1151 bytes)