Leysop 4mm Fast Risetime
RTP Pockels Cell

                      Different drivers have been built for this Pockels cell. This driver is used for slicing pulses with
                      a very fast risetime of 1.5nsec. Repetition rate is 100kHz.


                      This oscilloscope trace below shows the measurement of the optical transmission in a single-pass setup
                      measured with a photodiode of risetime 0.5nsec.
                      Parameters: 1064nm, 1.65kV, time difference of On/Off triggers 2.4nsec.

LR4fr_pp.gif





                      The oscilloscope trace below shows a high resolution measurement of the rising edge in a single-pass setup.
                      Parameters: 1064nm, 1.65kV, time difference of On/Off triggers 20nsec.

LR4fr_re.gif





                      The oscilloscope trace below shows a high resolution measurement of the falling edge in a single-pass setup.
                      Parameters: 1064nm, 1.65kV, time difference of On/Off triggers 20nsec.

LR4fr_fe.gif



 

hrs026.GIF (1088 bytes)

||  home  ||  products  ||  contact  ||

hr026.gif (1151 bytes)